Home / Drivers, Receivers, Transceivers / MAX3291ESD+T/
MAX3291ESD+T

MAX3291ESD+T

Manufacturer No:

MAX3291ESD+T

Description:

IC TRANSCEIVER FULL 1/1 14SOIC

Datasheet:

Datasheet

Delivery:

Payment:

Please send RFQ , we will respond immediately.

MAX3291ESD+T Specifications

  • Type
    Parameter
  • Supplier Device Package
    14-SOIC
  • Package / Case
    14-SOIC (0.154", 3.90mm Width)
  • Mounting Type
    Surface Mount
  • Operating Temperature
    -40°C ~ 85°C
  • Voltage - Supply
    4.75V ~ 5.25V
  • Data Rate
    10Mbps
  • Receiver Hysteresis
    35 mV
  • Duplex
    Full
  • Number of Drivers/Receivers
    1/1
  • Protocol
    RS422, RS485
  • Type
    Transceiver
  • Packaging
    Tape & Reel (TR)
  • Product Status
    Active
  • Series
    -
The MAX3291ESD+T is a specific integrated circuit (IC) chip manufactured by Maxim Integrated. It is a high-speed, low-power, quad-channel level translator designed for translating voltage levels between different logic families. Here are some advantages and application scenarios of the MAX3291ESD+T IC chip:Advantages: 1. High-Speed Operation: The MAX3291ESD+T supports high-speed data rates up to 100Mbps, making it suitable for applications requiring fast data transmission. 2. Low Power Consumption: This IC chip is designed to operate at low power, making it energy-efficient and suitable for battery-powered devices. 3. Quad-Channel Design: The MAX3291ESD+T has four independent channels, allowing for simultaneous voltage level translation for multiple signals. 4. Wide Voltage Range: It supports voltage translation between different logic families, such as TTL, CMOS, and LVCMOS, with a wide operating voltage range of 1.2V to 5.5V.Application Scenarios: 1. Mixed Voltage Systems: The MAX3291ESD+T is commonly used in systems where different components or subsystems operate at different voltage levels. It enables seamless communication and data transfer between these components by translating the voltage levels. 2. Interface Conversion: It can be used to convert voltage levels between different interfaces, such as UART, SPI, I2C, or GPIO, allowing devices with incompatible voltage levels to communicate with each other. 3. Microcontroller Interfacing: The MAX3291ESD+T can be used to interface microcontrollers or digital signal processors (DSPs) operating at different voltage levels with other peripheral devices, such as sensors, displays, or memory modules. 4. Industrial Automation: In industrial automation systems, where various sensors, actuators, and control devices operate at different voltage levels, the MAX3291ESD+T can be used to ensure proper communication and compatibility between these devices. 5. Consumer Electronics: It finds applications in consumer electronics devices, such as smartphones, tablets, or wearable devices, where different components may operate at different voltage levels, and voltage translation is required for proper functioning.It's important to note that the specific advantages and application scenarios may vary depending on the system requirements and the overall design. It is recommended to refer to the datasheet and consult with the manufacturer or technical experts for detailed information and guidance on using the MAX3291ESD+T IC chip.
MAX3291ESD+T Relevant information